目录简介 | Contents
0. Introduction
0.1 Definition of Terms
0.2 Category Management Requirements of Manufacturing Enterprises
0.3 Requirements on Using Testing Resources of Manufacturing Enterprises
1. Scope
2. Certification standards
3. Certification mode
3.1 Basic Certification Mode
3.2 Applicability of Certification Mode
4. Division of Certification Units
4.1Door lock
4.2 Door hinge (hinge)
5. Certification delegation
5.1 Proposal and Acceptance of Certification Application
5.2 Application Materials
5.3 Certification Arrangement
6. Implementation of Certification
6.1 Type Test
6.2 Initial Factory Inspection
6.3 Certification Evaluation and Determination
6.4 Certification Time Limit
6.5 Service parts of Discontinued Vehicle Models
7. Supervision after getting the certificate
7.1 Trail Inspection after getting the certificate
7.2 Sampling Test or Inspection at the Production Site
7.3 Market Sampling Test or Inspection
7.4 Frequency and Time of Supervision after getting the certificate
7.5 Record of Supervision after getting the certificate
7.6 Evaluation of Supervision Result after getting the certificate
8. Certificate
8.1 Validity of the Certificate
8.2 Content of the Certificate
8.3 Modification of the Certificate
8.4 Cancellation, Suspension and Revocation of the Certificate
8.5 Use of the Certificate
9. Certification Mark
9.1 Marks Allowed to Use
9.2 Using Requirements
10. Charge
11. Certification Responsibility
12. Procedures and Time Limit Related to Technical Disputes, Complaints and Appeals
Appendix I Requirements of Production Consistency Control Plan
Appendix II: Certification Implementation of Service parts of Discontinued Vehicle Model
|
中文版 
English
