目录简介 | 1. General Rules 2. Manufacturing of Test Structural Members and Fundamental Mechanical Properties of Materials 3. Instrumentations, Loading Equipment and Testing Devices 3.1 Instrumentations 3.2 Loading Equipment 3.3 Testing Devices 4. Test Load and Loading Methods 4.1 Loading Schema and Loading Plans 4.2 Determination of Test Load 4.3 Loading Procedure 5. Preparation before Test 6. Measurement of Distortion 6.1 Bulk Distortion for Test Structural Members 6.2 Partial Distortion for Test Structural Members 6.3 Measuring Time of Distortion for Test Structural Members 7. Cracking Test and Crack Measurement 7.1 Cracking Test for Test Structural Members 7.2 Measurement of Cracks of Test Structural Members 8. Determination of Carrying Capacity 9. Arrangement and Analysis of Testing Materials 9.1 Arrangement of original Testing Materials 9.2 Arrangement of Test Results of Distortion Measurement 9.3 Arrangement of Results of Cracking Test and Crack Measurement 9.4 Arrangement of Result of Carrying Capacity Test 9.5 Error and Statistic Analysis of Test Results 10. Special Tests 10.1 Testing for Mechanical Properties of Concrete Structural Members under Low Cyclic Reverse Loads 10.2 EquiAmplitude Fatigue Test of Concrete Structural Members 10.3 Contrast Test of Adhesion Strength of Fixture and Concrete 11. Safety and Protection Measures Appendix A Loading Devices Appendix B Recording Forms of Regular Tests Appendix C Descriptions of Wording in This Standard Additional Instructions |