目录简介 | Contents
1 General Principles
2 Terms and Symbols
2.1 Terms
2.2 Symbol
3 Preparations for Construction
3.1 Technical preparation
3.2 Technical data
3.3 Unpacking inspection and management
3.4 Construction site possessed condition
3.5 Foundation acceptance and treatment
4 Machine Installation
4.1 Installation with sizing block
4.2 No-sizing block installation
4.3 Anchor bolt
4.4 Lifing in place, levelling and alignment
4.5 Grouting
5 Cleaning and Assembly
5.1 General regulations
5.2 The bolt, key and guide pin assembly
5.3 Rolling bearing assembly
5.4 Sliding bearing assembly
5.5 Stationary fit piece assembly
5.6 Sealing member assembly
5.7 Transmission belt, chain and gear assembly
6 Auxiliary Facility and Pipeline Installation
6.1 Auxiliary facility installation
6.2 The pipe installation of oil system and miscelleous systems
6.3 Pipeline and machine connection
7 Pre-test Run
7.1 The division of labor and responsibility for pre-test run
7.2 Condition and preparation for pre-test run
7.3 System test and public works test run working
7.4 Solo test run
8 Documents for Project Completion
Appendix A Mud-jack method or base mortar method placing sizing block
Appendix B No-sizing block installation
Appendix C Anchor bolt screwing down moment and axial tension reference value
Appendix D Coupling alignment and leveling operation procedure
Appendix E Proportioning of concrete for grouting
Appendix F Dispensation and selection for cleaning solution
Appendix G Common derusting method and quality requirements
Appendix H Common anti-seizing agent
Appendix J Calculation method for bolt rigidity, connected piece rigidity and fastening moment
Appendix K Assembly method for stationary fit and transition fit
Appendix L Vee belt tensile force adjustment
Appendix M The mixing proportion of the pipeline pickling liquor
Appendix N The wording explanation of the national standard |
中文版 
English
