Foreword
1 General
2 Terms and Symbols
2.1 Terms
2.2 Symbols
3 Design Reference
4 Structural composite design
4.1 Subgrade
4.2 Bed course
4.3 Base course
4.4 Surface course
4.5 Road shoulder
4.6 Surface drainage
5 Joint design
5.1 Longitudinal joint
5.2 Traverse joint
5.3 Joint laying at intersections
5.4 End treatment
5.5 Filling and packaging material of joint
6 Design of the reinforcement in the surface
6.1 Reinforcement outline of the special part
6.2 The reinforcement layout of the concrete pavement
6.3 Layout of the reinforcement of continuous reinforced concrete
7 The material make up requirements and property parameter
7.1 Bedding layer material
7.2 Bed layer material
7.3 Surfacing material
7.4 Parameter of the material property.
8 The design of the additional layer structure
8.1 General provisions
8.2 Road damage condition assessment through investigation.
8.3 Investigation assessment of joint capacity and under board void
8.4 The structure coefficient investigation of the old concrete road
8.5 Additional layer structure design of the separated concrete
8.6 Additional layer structure design of the combined concrete
8.7 The structure design of the asphalted additional layer
Appendix A Traffic analysis
Appendix B The procedure of stress analysis and thickness calculation of the concrete board
Appendix C Stress analysis of the double layer concrete board
Appendix D The stress analysis of the asphalted concrete board
Appendix E Calculation of the vertical reinforcement in the continuous reinforced concrete surface
Appendix F Material parameter for reference from experience
Explanations on wordings in this Standard | 
中文版 
English
