目录简介 | 1 Scope This standard specifies the technical requirements of test method, data acquisition and interpretation of well test. This standard is applicable to well test design, data acquisition and interpretation of oil wells and water injection wells, and the application of the interpretation results. 2 Normative reference The following normative documents contain provisions which, through reference in this standard, constitute provisions of this standard. For dated references, subsequent amendments to, or revisions of, any of these publications (exclude errata) do not apply. However, parties to agreements based on this standard are encouraged to investigate the possibility of applying the most recent editions of the normative documents indicated below. For undated references, the latest edition of the normative document referred to applies, SY/T 5098 Technical conditions for the calculagraph used in donmhole instruments SY/T 5099 Grading and matching of downhole instruments according to measured temperature and pressure SY/T 5387 Geologic technical requirements of production test in conventional oil reservoir Technical specification of conventional formation testing SY/T 5968 Assessment methods of the data quality of well testing and production test in exploration wells SY/T 6013 Specification of data acquisition of conventional well test SY/T 6102 Oil field development monitoring and data requirement 3 Well test design 3. 1 Purposes of welt test 3.1.1 To determine the formation pressure, formation temperature, flowing pressure and flowing pressure gradient. 3.1.2 To derive the deliver Ebility equation of the tested oil well, to determine the water injectivity index of the tested water injection well- so as to realize the productivity of the tested oil well or the injectivity of the tested water injection well.
|