目录简介 | Contents Foreword 1 Scope 2 Normative references 3 Preparation before operation 4 Casing running operation Annex A (Normative) Table of make - up torque for standard round thread casing Annex B (Normative) Table of make - up torque for buttress thread casing ——————————————————————————————————— 1 Scope This standard specifies the technical requirements for casing running operations in vertical well, directional well, horizontal well and extended-reach well. This standard is applicable to casing running operations in oil and gas well. 2 Normative references The following normative documents contain provisions which, through reference in this standard* constitute provisions of this standard. For dated references, subsequent amendments to, or revisions of, any of these publications (exclude errata) do not apply. However, parties to agreements based on this standard are encouraged to investigate the possibility of applying the most recent editions of the normative documents indicated below. For undated references, the latest edition of the normative document referred to applies. SY/T 5199 Thread compounds for casing, tubing and line pipe (neq API RP 5A3) SY/T 5322 Design method of casing string strength SY/T 5334 Calculation method of casing centralizer installation interval SY/T 5396 Well-site transportation and inspection criterion for oil casing 3 Preparation before operation 3.1 Data preparation Before running in casing, the following data shall be collected: casing program, actual depth, bottom hole assembly, kick-off point, hole inclination and azimuth, horizontal displacement ,bottom hole temperature, hole diameter from caliper logging, mud properties, formation fluid properties, geologic zonation and lithology in the open hole,and well conditions, etc. 3.2 Wellbore preparation 3.2.1 The well depth meets the requirement of drilling design. 3.2.2 Wellbore quality conforms to the design requirement. 3.2.3 Before running in the casing, a wiper trip is required with the original drill stem, and the following requirements shall be satisfied.
|