目录简介 | Contents
Introduction
1 Scope
2 Normative References
3 Terms and definitions
4 Statutory requirements
5 Basic design
5.1 General
5.2 Permissible speeds
5.3 Permissible discharge temperature
5.4 Rod and gas loads
5.5 Critical speeds
6 Compressor components
6.1 Compressor cylinders
6.2 Valves and unloaders
6.3 Pistons, piston rods and piston rings
6.4 Crankcases, crankshafts, connecting rods, bearings and crossheads
6.5 Distance pieces
6.6 Packing cases and pressure packing
6.7 Nameplates and rotation arrows
7 Materials
7.1 General
7.2 Pressure-containing parts
7.3 Castings
7.4 Forgings
7.5 Fabricated cylinders and cylinder heads
7.6 Repairs to castings and forgings
7.7 Welding
7.8 Low temperature service
8 Lubrication
8.1 Compressor frame lubrication
8.2 Cylinder and packing lubrication
9 Accessories
9.1 Drivers
9.2 Couplings and guards
9.3 Reduction gears
9.4 Belt drives
9.5 Mounting plates
9.6 Intercoolers and aftercoolers
9.7 Air intake filters
9.8 Special tools
10 Controls and instrumentation
10.1 General
10.2 Control systems
10.3 Instrument and control panels
10.4 Instrumentation
10.5 Alarms and shut-downs
10.6 Electrical systems
10.7 Vibration and position detectors
11 Piping and appurtenances
11.1 General
11.2 Frame lubrication oil piping
11.3 Forced-feed lubricator tubing
11.4 Coolant piping
11.5 Instrument piping
11.6 Process piping
12 Pulsation and vibration control
12.1 General
12.2 Design approaches
12.3 Pulsation suppression devices
12.4 Supports for pulsation suppression devices
13 Inspection and testing
13.1 General
13.2 Inspection
13.3 Testing
14 Preparation for shipment
15 Vendor's data
15.1 General
15.2 Proposals
15.3 Contract data
Annex A (Informative) Data sheets and check-list
Annex B (Informative) Required capacity, manufacturer's rated capacity and no negative tolerance
Annex C (Informative) Piston rod and runout
Annex D (Informative) Repairs to grey or nodular iron castings
Annex E (Informative) Examples of typical logic diagram showing critical functions
Annex F (Informative) Vendor drawing and data requirements
Annex G (Informative) Figures and schematics
Annex H (Informative) Materials for major component parts
Annex I (Informative) Distance piece vent, drain and buffer systems to minimize process gas leakage
Annex J (Informative) Reciprocating compressor nomenclature
Annex K (Informative) Inspector's check-list
Annex L (Informative) Typical mounting plate arrangement 209
Annex M (Informative) Pulsation and vibration control studies
Annex N (Informative) Guideline for compressor gas piping design and preparation for an acoustic simulation analysis
Annex O (Informative) Guidelines for sizing low pass acoustic filters
Annex P (Informative) Compressor components — compliance with withstanding hydrogen sulfide materials
Annex Q (Informative) Alarm and shut-down systems
Annex R (Informative) References and Bibliography in ISO 13707: 2000
Annex S (Informative) Technical differences and reasons with ISO 13707:2000
|
中文版 
English
