Preview |
Contents Foreword Introduction 1 Scope 2 Normative References 3 Terms 4 Basic Safety Requirements 4.1 General 4.2 Personnel protection 4.3 Accessibility of maintenance and inspection 4.4 Fire protection 4.5 Rated speed 4.6 Strokes 4.7 Rated load 4.8 Load control 4.9 Car area 4.10 Number of passengers 4.11 Mechanical strength 4.12 Protection which avoid of harmful affects from outside to machinery 4.13 Protection level for outdoor purpose 4.14 Minimum 5 Well 5.1 General 5.2 Well enclosure 5.3 Headroom 5.4 Pit 5.5 Personnel protection of lower spaces of car and counterweight or balancing weight 5.6 Well wall 5.7 Strength of well 5.8 Access door and trap door 6 Lift Well Entrance 6.1 General provisions 6.2 Width of landing door 6.3 Clear height of landing door entrance 6.4 Landing door structures 6.5 Locking and closing of landing doors 6.6 Emergency unlocking 6.7 Electrical device for proving the landing door closed 6.8 Electrical device for proving the closed condition of the panels of multi-panel sliding door 6.9 Risk of getting stuck for the personnel working in the lift well 7 Car 7.1 Car entrance 7.2 Clear width and height of car 7.3 Effective area of car 7.4 Car roof 7.5 Car wall 7.6 Ventilation 7.7 Surface of floor 7.8 Apron 7.9 Operating panel 7.10 Handrail 7.11 Folding chair 7.12 Lighting 7.13 Protection of car entrance 8 Counterweight and Balancing Weight 9 Guidance system 9.1 Car guidance system 9.2 Counterweight/balancing weight guidance system 9.3 Guided travel 9.4 Guide rails 10 Safety Gear and Overspeed Governor 10.1 Safety gear 10.2 Overspeed governor 11 Buffers 11.1 Lower buffer 11.2 Top buffer 12 Clearance between car and wall facing the car entrance, and between components 12.1 Clearance between car and wall facing the car entrance 12.2 Clearance between components 13 Driving System 13.1 General requirements 13.2 Braking system 13.3 Emergency operation 13.4 Additional requirements for gear and rack drive 31 13.5.1 Ropes and chains 13.6 Additional requirements for rope traction 13.7 Additional requirements for screw and nut drive 13.8 Additional requirements for hydraulic drive 14 Electric Installation, Electric Control and Electric Protection 14.1 General 14.2 Power source 14.3 Main switch 14.4 Electrical wiring and electrical installation 14.5 Illumination 14.6 Socket 14.7 Main contactor 14.8 Motor powered by AC power source 14.9 Requirement of creepage distance, electric clearance and case 14.10 Electromagnetic compatibility 14.11 Protection of electrical failure 14.12 Electrical safety device 14.13 Protection of drive motor and its operation 14.14 Additional requirement of battery power supply 14.15 Control device 14.16 Emergency alarm device 14.17 Operation control 15 Test, Inspection and Record 15.1 Type test 15.2 Inspection 15.3 Records 16 Usage information 16.1 General 16.2 Information and alarm 16.3 Operation guidance 16.4 Document with equipment 16.5 Marking Appendix A (Normative) Trouble shooting of electrical element Appendix B (Normative) Periodical inspection and maintenance Appendix C (Normative) Type test procedure of safety part compliance authentication Reference
|